Bitmain Power Supply Fan

2 x 12038 fan over voltage protection.

Bitmain power supply fan.

Nema 6 15p to c13 power cord 6ft 250 220v cable for bitmain antminer apw3 apw7 power supply digital ballast cord industrial use u l certified and csa approved 14awg 15a 4 7 out of 5 stars 23 15 99 15. Replace the faulty power supply 3. I have 16 miners of all types the bitmain psu s are great. View return policy.

Re plug the line 2. There are a total of 10 plugs coming from the power supply so there will be one extra unused plug. In stock new antminer s9 13 5t bitcoin miner asic btc bitmain mining machine with power supply. 100 240 v a c.

View return policy 6 976 00. Power factor 0 95 full load leakage current 1 5 ma 220 v 50 hz protection low voltage input. Plug 6 pin 12v plugs from the bitmain power supply to the 8 positions on the hash boards and the one position on the control board. 2 x 12038 fan.

Plug in the ethernet cable to the antminer. Power off protection trip time 9 ms. Apw7 is a new power supply model released by bitmain especially for our antminers. This power cable works great.

The bitmain power supply works well for us residents. 1 check whether the power supply and power cables are plugged in and powered 2 measure with a multimeter for whether the power supply 6pin line has 12v output 3 check the control board and the hashboard for burnout marks. Check whether the fan is spinning or not. If gauge is too low it will not power the supply only the fan within.

Replace the control board. Psu repeatedly stops for a few seconds then resumes. 80 89 v a c. Check if power supply s output has been short circuited or overloaded.

This power supply is an upgraded version of apw3 and it has few technology advantages compared to our apw3. This would cause the power supply to the protection mode. 2 rear fans size. 5 pairs of 6 pin pcie connectors 10 connectors noise level 43 db input voltage range.

I highly recommend using a higher gauge power cord with it especially if using it to power a s9 t9 a3 or d3 220 volts. Cannot scan the miner. 95 105 v a c. Then plug in the power supply to the outlet pigtail.

Yes over load protection. 47 63 hz.